Which address is used in the address field of a ppp frame

WHICH ADDRESS IS USED IN THE ADDRESS FIELD OF A PPP FRAME FULL

Usually each Internet provider gets a block of IP and then dynamically assigns one to each newly attached PC for the duration of its login session because there are not much IP. The PC needs an IP address to run a TCP/IP protocol stack. PC sends the router a series of LCP packets in the payload field of one or more PPP frames.ДЄfter this a series of NCP packets are sent for the purpose to configure the network layer. PC calls the providerвЂ™s router via a modem and when the routerвЂ™s modem has answered the phone then physical connection is made. We will see what happens when a home user calling up an Internet service provider to make a home PC a temporary Internet host.

The method chosen is to have a different NCP (Network Control Protocol) for each network layer supported. A way to negotiate network-layer options in a way that is independent of the network layer protocol to be used.It supports synchronous and asynchronous circuits and bit-oriented and byte-oriented encodings. A link control protocol is used for bringing lines up and down when required, negotiating options, testing and is called as LCP (Link Control Protocol).A framing method that without separates, one frame to another without complexity and also handles error detection.Point to Point protocol is used for various reasons like router to router traffic, error detection, supports multiple protocols, IP addresses can be negotiated during connection.

WHICH ADDRESS IS USED IN THE ADDRESS FIELD OF A PPP FRAME FULL

In this post, I will discuss about The Point-to-Point Protocol, The PPP full frame format for unnumbered mode operation, and Explanation of Method to bring Internet Lines Up and Down in Computer Networks.

Which address is used in the address field of a ppp frame